2 - 16 Chapter 2
Chapter 2 - Blade Installation and Startup
● Connection for Memory Module
● DTMF Tone Sender
● DTMF Tone Receiver
● System Tone Sender
● MFC Tone Sender
● MF Signal Sender (Sends caller information to CO for E911)
● Call Progress Tone Detection
● C-Channel Control
● Conference: 64 Channels (32 channels x 2 circuits)
● Caller ID Receiver
● Caller ID Generator
● A load switch which is used for initial system startup, resetting the system, or when
upgrading system software
● One USB Port - USB 1.1
● One Gbit Ethernet Port for VOIPDB
● One Fast Ethernet Port (10/100 Base-T), auto negotiation and VLAN
● One CompactFlash Blade Slot
● Background Music/EXSP Control Port
● Status LED
● One EXIFU Interface Connector
● Two Audio Input/Output Terminals (sub-mini jacks)
● One General Purpose Control Terminal
● Call Control Server (ex: Multimedia Conference Server, Voice Mail Server, SIP Server,
RTP Forwarding, VoCoder Conversion)
● One lithium battery (Sony CR2032 or equivalent) which provides battery back-up of
system data
The CCPU functions provided are:
● Call Control Server
● Multimedia Conference Server (Conference Server requires PVAU and compact flash
card)
● Voice Mail Server (voice mail requires a compact flash card)
● SIP Server
● RTP Forwarding
● VoCoder Conversion
To Next Page
Loading...
