NEC UX5000 - Installing the Voip Blade; LED Indications

2 - 36 Chapter 2
Chapter 2 - Blade Installation and Startup
2.4.5.1 LED Indications
The following table shows the LED indication when transmitting or receiving data on CN1.
2.4.5.1 Installing the VoIP Blade:
1. With the system power off, install the VOIPDB onto the CCPU.
2. Insert the CCPU into the CCPU slot in the Controlling chassis.
● Refer to UX5000 Central Processing Unit (CCPU) Blade (Figure 2-4 - Figure 2-5)
- P/N 0911001
(page 2-15) for more details.
3. Connect the VOIPDB to the 4RTU blade or to an external switching hub using an ethernet
cable.
LED Function
LED
Status
Operation Status
ACT (LED 1) Link activity or data
transmission and reception.
On Green Link up completed
Flashing Data being transmitted/
received.
LINK10_100
(LED2)
10Base-T/100Base-TX link
speed indicator.
On Red 100Base-TX link up
When:
LED 1=On
LED 2= Off
LED 3=Off
Link up 10Base-T
LINK1000
(LED3)
1000Base-T link speed
indicator
On Red 1000Base-T link up
DUPLEX
(LED4)
Duplex Status On Yellow Full duplex operation
LED
Link Up
Auto Negotiation Mode Force Mode
1000
M bps
100Mbps 10Mbps
1000
M bps
100Mbps 10Mbps
half full half full half full half full
ACT (LED1)
ON ON ON ON ON ON ON ON ON ON
DUPLEX (LED4)
ON OFF ON OFF ON ON OFF ON OFF ON
LINK1000 (LED3)
ON OFF OFF OFF OFF ON OFF OFF OFF OFF
LINK10_100 (LED2)
OFF ON ON OFF OFF OFF ON ON ON ON
• Do not remove or install this daughter board with the
power on.