3 - 28 Chapter 3
Chapter 3 - Installing Extensions and Trunks
3.14.2 Identifying Port Location
Port information such as blade type, port numbers, blade status, and individual port status can be obtained
from the UX5000. To obtain a System Report containing blade information, a USB flash drive must be
connected to the UX5000’s USB port on the CCPU or an Aspire CTA or CTU adapter must be used.
Running program 90-13-03 in MAINTENANCE PROGRAMS prints a system blade report. Refer to Program
90-13-03 : System Information Output in the Software Manual. The following is a typical report:
<<SYSTEM INFORMATION>> 01/03/03 09:49
slot location type assign port condition note
1 1-1 ESIU 1- 16 Running ****---- -------- Connect:*
2 1-2 ESIU 1- 8 Running
3 1-3 SLIU 1- 8 Running
4 1-4 COIU 1- 16 Running
5 1-5 COIU 1- 16 Running
6 1-6 DIOPU 1- 8 Not Install
7 1-7 - none -
8 1-8 - none -
9 2-1 - none -
10 2-2 - none -
11 2-3 - none -
12 2-4 - none -
13 2-5 - none -
14 2-6 - none -
15 2-7 - none -
16 2-8 - none -
To Next Page
Loading...
