Chapter 2 - Blade Installation and Startup
Chapter 2 2 - 85
2.7.6.3 To install a BRI Interface Daughter Board:
1. Set the SW1 and SW2 jumpers on the BRI blade for either T-Bus or S-Bus.
2. Set the SW1 and SW2 TR jumpers as either terminated or unterminated.
3. Attach the BRI daughter board to the BRI blade by lining up the CN5 connectors and pressing
the boards together.
4. Plug the BRI blade into the system chassis.
5. Before proceeding to Step 7, wait to verify that the STATUS LED starts to flash.
● With normal operation, the status LED will flash fast. If trouble was found during the self
diagnostics routine, the status LED will flash slow.
● Once connected, the ISDN Layer Link Status LEDs will not indicate the status of the
Layer 1 link.
6. Connect the cable from the NT1 Network Termination cable to the CN7 or CN8 connector on
the BRI blade and/or BRI daughter board.
To Next Page
Loading...
