Chapter 2 - Blade Installation and Startup
Chapter 2 2 - 77
2.7.4.4 Installing the 4TLIU Blade:
1. Install the 4TLIU into a slot.
● With normal operation, the status LED will flash fast. If trouble was found during the self
diagnostics routine, the status LED will flash slow.
2. Use Program 10-03-02 to set to 2- or 4-wire.
3. Use Program 10-03-03 to select Type I or V.
Figure 2-36: CONTROL SIGNAL CONNECTION
To Next Page
Loading...
