NEC UX5000 - Bracket Installation for Desktop Position with Chassis-B (Figure 1-66 - Figure 1-69)

1 - 50 Chapter 1
Chapter 1 - Installing the Chassis
1.7.5 Bracket Installation for Desktop Position With Chassis-B (Figure 1-66 - Figure 1-69)
If you choose to place the Chassis-B on top of a desk or similar position, use the following steps to attach the
brackets to allow for a stable system placement. If the area is unstable or if their could be vibrations on the
desk, it is recommended to use the floor-mounting setup instead.
1. Position the chassis so that the EXIFU slot is to the top. Insert tabs a and b into the tab holes A and B on
the chassis.
Figure 1-66: POSITION THE FIRST MOUNTING BRACKET
Note that this bracket is not for use with a combined Chassis-B/E.
(A combined Chassis-B/E should only be rack, wall, or floor mounted.)