NEC UX5000 - Removing the EXIFU Cover (Figure 2-8); To Install an EXIFU Blade

Chapter 2 - Blade Installation and Startup
Chapter 2 2 - 27
2.4.2.2 Removing the EXIFU Cover (Figure 2-8)
1. Press on the right-hand side of the EXIFU cover and pull the cover open. Slide the cover
slightly to the left to unhook the 3 hooks which hold on the cover.
2.4.2.3 To install an EXIFU blade:
1. Remove the EXIFU cover as described previously from each of the chassis.
2. Carefully remove the blank filler piece on the cover to allow for the EXIFU connectors.
3. For the Controlling Chassis-B1 (with the CCPU), install the EXIFU-B1 into the slot.
4. For the Base Chassis-B1(s), install the EXIFU-E1 into the slot in each of the additional
chassis. Screw the blade to the chassis using the screw provided.
Figure 2-8: REMOVING THE EXIFU COVER
• Do not remove or install this blade with the power on.