Chapter 2 2 - 1
Chapter 2 - Blade Installation and Startup
Chapter 2 -
Blade Installation
and Startup
SECTION 2-1
BLADE LAYOUT
2.1.1 Blade Location
Determine the slot position for each blade. In the Controlling chassis:
● Slot 1 - dedicated for the CCPU
● EXIFU slot - dedicated for the Expansion blade
In the Expansion Chassis:
● EXIFU slot - dedicated for the Expansion blade
The Controlling/Base and Expansion Chassis:
● Slots 2-16 are universal (any type of blade can be installed)
Important Notes
● Make sure to follow the steps indicated in Powering Up the System/Initial Blade
Installation
(page 2-91) for an initial system install. This will ensure that you start the
system with the default system settings.
● To delete a blade from the system, the blade must first be removed from the system
chassis, then Program 90-05-01 can be used to delete the slot definition.
To Next Page
Loading...
