4 - 68 Chapter 4
Chapter 4 - Terminals and Optional Equipment
4.17.2 Installing the SLT Adapter
1. Punch down one pair 24 AWG station cable for each SLT Adapter to a cross-connect block.
2. Run one-pair cross-connect from the cross-connect block to the extension (B) block for each SLT
Adapter.
3. Connect the extension (B) block's 25-pair cable to the corresponding RJ-61 connector on the ESIU
blade.
4. Install bridging clips on the extension (B) block.
5. Install a modular jack for the SLT Adapter within six feet of the module’s location.
6. Terminate the station cable WHT/BLU - BLU/WHT leads to the RED and GRN lugs in the modular jack.
7. Plug a line cord into the SLT Adapter’s connector marked “ESIU”. Plug the opposite end of the line cord
into the modular jack.
8. Plug a second line cord into the SLT Adapter’s connector marked “TEL”. The opposite end of the line
cord should be plugged into the analog device to be used.
Refer to Single Line Terminals in the Software Manual for programming details.
Figure 4-38: INSTALLING THE SLT ADAPTER
Analog Single Line
Telephone
To ESIU
Port
To Next Page
Loading...
