Chapter 1 - Installing the Chassis
Chapter 1 1 - 25
1.6.2.1 Installing the Long-Term Battery Box
1. Position the floor-mount box in a location which provides enough access around the unit to
allow for access to the equipment. Secure the box with 4 10mm anchor bolts.
2. Place the long-term battery box on top of the floor-mount box. Secure the unit by attaching the
upper joint brackets to either side of the battery box and floor-mount box. Four screws total on
each bracket are used - two screw into the battery box and two screw into the floor-mount box.
3. Remove the screw on the right side of the front cover of the battery box. Slide the cover to the
right slightly and remove it.
Figure 1-31: MOUNTING BATTERY BOX TO FLOOR MOUNT BOX
Figure 1-32: REMOVE FRONT COVER OF BATTERY BOX
To Next Page
Loading...
