2 - 96 Chapter 2
Chapter 2 - Blade Installation and Startup
2.9.4 Setting Up Extension Circuit Types
Use Program 10-03 to set up extension circuit types as required. The system will automatically detect and
assign most circuit types when the device is connected. Refer to the Software Manual for programming
information.
1. Enter 10-03-01.
2. Select the slot, port or channel (with ESIU blades) to be programmed.
3. Set the terminal type or option as needed.
● Refer to the Software Manual for this information.
● If the system has DSS Consoles, Program 30-02 must be used to define DSS extension
assignments.
● As the system recognizes the extension devices automatically, when replacing the type of
device connected, the type must be undefined in Program 10-03 prior to connecting the new
device. For example, if a port was previously used for a keyset and a DSS Console is to be
installed in that same port, it must first be undefined in Program 10-03 before the console is
connected.
Figure 2-43: TELEPHONE KEY LAYOUT
To Next Page
Loading...
