NEC UX5000 - Wall-Mount Bracket; Using the Wall-Mount Bracket; Installing the Keyset Wall-Mount Bracket (Figure 4-51 - Figure 4-53)

Chapter 4 - Terminals and Optional Equipment
Chapter 4 4 - 89
SECTION 4-21
WALL-MOUNT BRACKET
4.21.1 Using the Wall-Mount Bracket
Each UX5000 terminal/console provides the ability to wall-mount the equipment using a standard wall-mount
plate. This allows the terminal to be mounted to a wall at a convenient location.
Terminals with an ADA or APR adapter installed must use a wall-mount adapter (P/N 680610).
4.21.2 Installing the Keyset Wall-Mount Bracket (Figure 4-51 - Figure 4-53)
1. Flatten the legs on the equipment (terminal/console) to be wall-mounted.
2. Connect the line cord cable from the terminal to the jack in the wall-mount plate.
3. Position the equipment to be wall-mounted over the 2 support screws on the wall-mount plate.
4. Gently slide the equipment down over the support screws, ensuring that both the top and bottom screws
are covered.
● The equipment should snap into place. Make sure the equipment is securely attached.
Figure 4-51: ATTACHING TO THE WALL-MOUNT PLATE