NEC UX5000 - Router 4-Port (RTU) Blade (Figure 2-28)

To Next Page

To Previous Page

Chapter 2 - Blade Installation and Startup

Chapter 2 2 - 59

2.6.2

Router 4-Port (RTU) Blade (Figure 2-28) - P/N 0911062

This blade is an in-skin router for the UX5000. Using an RJ45, a connection can be made directly to a PC. This

blade combines multiple voice and data features into an in-skin converged networking route. The Router blade

includes a single T1 WAN interface and an integrated 4-port managed Ethernet switch with VLAN support. In

addition, an 8-port license is provided with this blade to allow for QoS on 8 simultaneous SIP calls. (Any calls

over the 8th call will go through, however, it will not have any priority queuing.)

The Router blade provides:

● High Speed Forwarding (Routing). IPsec forwarding ability is about 100 Mbps.

● Supported Interface:

- T1 WAN Port

- 10/100 Base-TX Ethernet WAN Port

- 4 Switched LAN Ethernet Ports (10/100/1000 BaseT) with VLAN and Port Mirroring

Capabilities

● VPN/Firewall

● 15 VPN Tunnels

● VoIP Application Layer Gateway (SIP, MGCP and H.323) Resolves NAT/Firewall Traversal Issues

● QoS: Priority Queuing, Traffic Shaping, Diffserv Marking/Policing

● VoIP Call Admission Control

Figure 2-28: ROUTER BLADE

NEC UX5000 - Router 4-Port (RTU) Blade (Figure 2-28) - P;N 0911062