2 - 90 Chapter 2
Chapter 2 - Blade Installation and Startup
2.7.7.3 To install a T1/PRI Interface Blade:
1. In system programming (10-51) select either T1 or PRI.
● If the blade has already been installed, you may need to remove the blade, undefine the
slot in Program 90-05, redefine the blade in Program 10-51, then reinstall the blade.
2. Plug the T1/PRI Interface blade into any universal slot.
● With normal operation, the status LED will flash fast. If trouble was found during the self
diagnostics routine, the status LED will flash slowly.
● Once connected, the ISDN Layer Link Status LEDs will be on steady when the Layer
link is established. If there is no link, the LED will be off.
3. Connect the cable from the NT1 Network Termination cable to the CN2 connector on the T1/
PRI blade.
● The CSU connects to the network through an 8-pin RJ45/RJ48 connector. Use either
the RJ48C plug-to-RJ48C plug which ships with the CSU or an RJ45/48C plug-to-RJ45/
48C plug straight through or CAT5 cable to connect the T1 to the CSU. See the table
which follows for the Network and Terminal interface pinouts.
4. In system programming (10-03) set the blade for PRI Mode or T1 Mode.
To Next Page
Loading...
