Chapter 4 - Terminals and Optional Equipment
Chapter 4 4 - 13
4.4.4 Programming the IP Terminal for the Dial Pad and Line Key Kit
1. Enter the terminal’s program mode by pressing HOLD CONF * #.
2. At the log-in screen, enter the user name (default: ADMIN) and password (default: 6633222) and press
the OK Soft Key.
3. Press Soft Key 3 for “Maintenance Setting”.
4. Press Soft Key 4 for “Adjust”.
5. Press Soft Key 2 for “Key Kit Type”.
6. Select the type of dial button kit being used by pressing the Up/Down key.
7. Press Soft Key 4 for “Next”.
8. Select the type of line key kit being used by pressing the Up/Down key. By default, the correct line key kit
for the dial button kit selected above will be highlighted.
9. Press Soft Key 4 for “OK” to complete.
10. Continue pressing Soft Key 4 to exit (Exit-Exit-Save). The terminal will reset automatically.
Line Key Entry Description
Kit1 Type A - Japan with cursor key
Kit2 Type A - US with cursor key
Kit3 Type B - US with cursor key
Kit4
Kit8 32 Line Key without cursor key
Kit 9 Type A - Japan without cursor key
Kit10 Type A - US without cursor key
Kit11 Type B - US without cursor key
Kit12
Line Key Entry Description
Line12 Enhanced 12-Button
Line24 Enhanced 24-Button
Line32 Enhanced 32-Button
Line8 DESI-Less
Line6 Value 6-Button
Line2 Value 2-Button
Line0 IP-CTS
To Next Page
Loading...
