Chapter 2 - Blade Installation and Startup
Chapter 2 2 - 37
4. Within UX5000 programming, Program 10-12-01 : CCPU Network Setup - IP Address must
be set to 0.0.0.0. After disconnecting the LAN connection on the CCPU, reboot the UX5000 so
the change will take effect.
● Without this change, problems can occur with IP terminals, CygniLink and AspireNet
with no audio or one-way audio. This can also cause SIP MLT sets to not register to the
UX5000.
5. Refer to the UX5000 Software Manual (P/N 09193200) for further programming.
✎ To view the VOIPDB information (MAC address, number of ports, number of active/reserved), on a display
terminal press CHECK + HOLD + 4.
Figure 2-16: VOIPDB DAUGHTER BOARD
To Next Page
Loading...
