Chapter 2 - Blade Installation and Startup
Chapter 2 2 - 19
! IMPORTANT!
After removing a previously installed CCPU, handle the blade carefully, from
the edges. If certain solder points/resistors are touched on the back of the
blade, some RAM/temporary memory may be lost (ex: time, date, user-
defined settings, etc.)
Figure 2-4: CCPU BLADE LAYOUT
Gbit Ethernet
<VOIPDB>
Fast Ethernet CN7
Status LED1
Status LED2
Status LED3
Status LED4
Serial CN6 (special use)
BGM/EXSP
Control Relay CN10
Aux In/Out BGM/EXSP
Control CN8
Aux In/Out BGM/EXSP
Control CN9
Load/SW1
USB CN5
VOIPDB
MEMDB
CN3
CN1
Battery
CN4
CN2
SW6
Status LED5
To Next Page
Loading...
