NEC UX5000 - Page 108

2 - 22 Chapter 2
Chapter 2 - Blade Installation and Startup
LED Indication
Status
RUN
(LED1)
LED2 LED3 LED4 LED5
System
Startup:
Off Off Off Off On Steady When USB
Memory is Connected
System initializing
Misc: Off On Off Access
Blink
On Steady When USB
Memory is Connected
Initializing the disk or formatting
System
Startup:
Off Off On On On Steady When USB
Memory is Connected
Boot program is initializing in the
flash memory
Misc: Off On On Access
Blink
On Steady When USB
Memory is Connected
Reading system software
Misc: On Blinking Blinking Blinking On Steady When USB
Memory is Connected
Upgrading system software
Misc: On Blinking Off Off On Steady When USB
Memory is Connected
Upgrading boot software
Misc: On Blinking Blinking Off On Steady When USB
Memory is Connected
Finish formatting (SRAM, Flash)
Normal
Operation:
Blinking Off Off Off On Steady When USB
Memory is Connected
System operating normally
Misc: Blinking Off Off On On Steady When USB
Memory is Connected
FPGA version error
Misc: Blinking Off On Off On Steady When USB
Memory is Connected
SRAM error
Misc: Blinking Off On On On Steady When USB
Memory is Connected
Flash memory booting error
Misc: Blinking On On On On Steady When USB
Memory is Connected
Flash memory data error
Misc: Blinking Blinking Blinking Blinking On Steady When USB
Memory is Connected
Reading error of system program
System
Startup:
Blinking Off Off Off On Steady When USB
Memory is Connected
System starting up
Alarms: Blinking On Off Off On Steady When USB
Memory is Connected
Error: Major Alarm occurred
Alarms: Blinking Blinking Off Off On Steady When USB
Memory is Connected
Error: Major Alarm occurred