NEC UX5000 - Page 224

4 - 6 Chapter 4
Chapter 4 - Terminals and Optional Equipment
5. Insert the cable into the proper CN4 or CN5 location while holding down the lock button (holding down
this lock button is easiest with a flat-head screwdriver). Once the cable is in place, release the lock
button.
● Refer to the specific function being connected for more detail on 2PGDAD connections.
6. Repeat Steps 4 and 5 for any additional connections required.
7. Replace the cover and tighten the screw to hold the cover in place.
8. If required for the function being used, insert the RCA connectors into the CN2 (Channel 1) and CN3
(Channel 2) connectors on the back of the 2PGDAD module.
Figure 4-5: CONNECTING CABLE TO THE 2PGDAD MODULE
Figure 4-6: 2PGDAD MODULE CONNECTIONS
S3
S5
S4
S6
Open setting
Short setting
CN3
Channel 2
CN2
Channel 1
CN1
(to ESIU port)
RCA Plugs