NEC UX5000 - Page 244

4 - 26 Chapter 4
Chapter 4 - Terminals and Optional Equipment
8. Follow the feature programming as described in the UX5000 Feature Manual (P/N 0913201).
Figure 4-16: 2PGDAD CABLE CONNECTION
PGDAD Module
External Relay
Page Control
AC 117V
External Page
To 8/16
ESIU Blade
CN2 or CN3
CN1
CN2
CN3
Relay 5 - for CN2
Relay 6 - for CN3
Relay 7
Relay 8
The 2PGDAD module provides amplifiers for each page output port (for a
maximum of +8 dBM, 600 ohms at 1KHz). No additional page amplification is
provided by the 2PGDAD module and, if required, an external page amplifier
can be used for additional amplification.
The page output of the CCPU does not provide any amplification (for a
maximum output of -3 dBm, 600 ohms at 1KHz). If the paging volume is not
satisfactory using the CN8 or CN9 connector on the CCPU, it is recommended
that the 2PGDAD module be used instead.