4 - 62 Chapter 4
Chapter 4 - Terminals and Optional Equipment
4. Press the handset cradle release tab towards the cradle.
Figure 4-34: ATTACHING THE PSA
5. Slide the handset cradle away from the terminal and remove the connecting cable from the
terminal unit connector.
6. Plug in the cradle connecting cable of the PSA-R handset into the terminal unit connector.
7. Insert the tab on the PSA-R into the slot on the terminal base.
● The cradle connecting cable should be set into the groove to prevent it from being
pinched during the installation.
Figure 4-35: CONNECT THE PSA
To Next Page
Loading...
