NEC UX5000 - Page 348

6 - 36 Chapter 6
Chapter 6 - Specifications and Parts List
CCPU to Printer: LAN
UTP
10Base-T/
100Base-
TX
10Base-T: 4-wire
100Base-TX: 8-wire
328
LAN Equipment
(IP Terminal, Hub,
GBA Adapter, etc.)
LAN
(UTP)
CAT3 or
CAT 5
LAN (UTP) cable with
CAT3 or more for
10Base-T, and CAT5 or
more for 100 Base-TX
328.08 (100 meters) Regardless of whether it
receives power from the
AC adapter or switching
hub.
*CAT 5 recommended with GBA Adapter.
DID Trunks: CAT5 Analog DID = 2,500
ohms
OPX = 1,500 ohms
Includes SLT or exchange
Tie Line Trunks: CAT5 2-wire 26 AWG
2-wire 24 AWG
2-wire 22 AWG
13,123
20,997
34,777
Limitation depends on the
connecting Router,
Multiplexer or Exchange. If
the UX5000 is connected
to another UX5000
directly, up to 1,500 ohms
loop resistance (including
system).
2/4BRIU to ISDN
Terminals:
CAT5 4-wire 24 AWG Point-Multipoint short
connection: 329
Point-Multipoint long
connection: 984
Point-Point connection:
164-0
1PRIU to ISDN
Terminal:
CAT5 4-wire 24 AWG 164 From chassis to IP
terminal and within 328’.
ISDN Terminal: CAT5 4-wire 24 AWG Point-Multipoint Short
Connection: 328
Point-Multipoint
Extension: 984
Point-Point: 1640
UX5000 Cable Requirements
Device Cable Type Cable Run Length (ft) Notes