1 - 44 Chapter 1
Chapter 1 - Installing the Chassis
10. With either style mounting bracket: Reinstall the metals tabs (G and H) removed in Step 2. The
slot in the brackets should slide over the screw heads. Tighten the screws to secure the chassis.
11. If not attaching a Chassis-E, screw the plastic cover over the backboard connector to prevent dust/
foreign objects from entering the chassis.
12. With Style 2 mounting bracket: Secure 4 screws into the wall using the template provided for
proper placement. Leave the screw heads exposed approximately 3/16” to allow the bracket to slide over
the screws. Slide the chassis over the screw heads and move the chassis to the side and slightly down
allowing for the secure placement within the key-holes within the bracket.
13. If required, reposition the system label on the cover.
Figure 1-58: ATTACHING THE METAL BRACKETS
Figure 1-59: REVERSE THE UX5000 LABEL
To Next Page
Loading...
