1 - 48 Chapter 1
Chapter 1 - Installing the Chassis
4. On the lower U-bracket support, attach two screws on either side of the bracket. Do not tighten the
screws. There should be approximately 3/8” clearance on the screw head to allow for space when
installing the chassis with the L-bracket installed.
5. Place the chassis onto the U-brackets attached to the wall. The top L-bracket hooks onto the top support
bracket, while the bottom L-bracket slides under the screw heads on the U-brackets. Once hooked, the
chassis should be moved slightly to the right. Tighten the screws on the lower U-bracket to secure the
chassis into place.
Figure 1-63: HOOK THE CHASSIS-A ONTO THE WALL MOUNT BRACKETS
To Next Page
Loading...
