EasyManuals Logo

NETGEAR GS110TPv3 User Manual

NETGEAR GS110TPv3
492 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #166 background imageLoading...
Page #166 background image
8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Configure Switching User Manual166
This selection specifies the administrative mode for the voice VLAN for the switch. The
default is Disable.
8. Select the interface by taking one of the following actions:
• To configure a single interface, select the check box associated with the port, or type
the port number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the heading
row.
9. From the Interface Mode menu, select the voice VLAN mode for selected interfaces:
• Disable. This is the default value.
• None. Allow the IP phone to use its own configuration to send untagged voice traffic.
• VLAN ID. Configure the phone to send tagged voice traffic. You must enter the VLAN
ID in the Value field (see the next step).
• Dot1p. Configure voice VLAN 802.1p priority tagging for voice traffic. You must enter
the dot1p value in the Value field (see the next step).
• Untagged. Configure the phone to send untagged voice traffic.
10. In the Value field, enter the VLAN ID or dot1p value.
This field is enabled only if you select VLAN ID or Dot1p from the Interface Mode menu.
11. In the CoS Override Mode field, select Disable or Enable.
The default is Disable.
12. In the Authentication Mode field, select Enable or Disable.
The default is Enable. When the authentication mode is enabled, voice traffic is allowed
on an unauthorized voice VLAN port. When the authentication mode is disabled, devices
are authorized through dot1x.
Note: Authentication through dot1x is possible only if dot1x is enabled.
13. In the DSCP Value field, configure the Voice VLAN DSCP value for the port.
The range is from 0 to 64. The default value is 0.
14. Click the Apply button.
Your settings are saved.
The Operational State field displays the operational status of the voice VLAN on an
interface.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GS110TPv3 and is the answer not in the manual?

NETGEAR GS110TPv3 Specifications

General IconGeneral
BrandNETGEAR
ModelGS110TPv3
CategorySwitch
LanguageEnglish

Related product manuals