8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Manage Device Security User Manual302
For information about the credentials, see Credentials for the local browser interface on
page 32.
5. Click the Login button.
The System Information page displays.
6. Select Security > Management Security > RADIUS > Server Configuration.
7. In the Server Address field, specify the IP address of the RADIUS server.
8. In the Authentication Port field, specify the UDP port number that the server uses to verify
the RADIUS server authentication.
The range is from 1 to 65535. The default value is 1812.
9. From the Secret Configured menu, select Ye
s.
You must select Ye
s before you can configure the RADIUS secret. After you add the
RADIUS server, this field indicates whether the shared secret for this server was
configured.
10. In the Secret field, type the shared secret text string used for authenticating and encrypting
all RADIUS communications between the switch and the RADIUS server
.
This secret must match the RADIUS encryption.
11. From the Active menu, select Primary.
12. From the Message Authenticator menu, select Enable or Disable to specify whether the
message authenticator attribute for the selected server is enabled.
The message authenticator adds protection to RADIUS messages by using an MD5 hash
to encrypt each message.
The shared secret is used as the key, and if the message fails
to be verified by the RADIUS server, it is discarded.
13. Click the Add button.
The server is added to the switch.
14. T
o reset the authentication server and RADIUS statistics to their default values, click the
Clear Counters button.
To Next Page
Loading...
Need help?
General