8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Manage Device Security User Manual321
If you do not know the IP address of the switch, see Access the switch on-network and
connected to the Internet on page 19 or Access the switch off-network on page 30.
The login page displays.
If the NETGEAR Business page displays, see
Register and access the switch with your
NETGEAR account on page 34.
4. Enter one of the following passwords:
• After registration, enter the local device password.
By default, the local device password is password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see
Credentials for the local browser interface on
page 32.
5. Click the Login button.
The System Information page displays.
6. Select Security >
Access > HTTPS > HTTPS Configuration.
7. Select the Admin Mode Enable or Disable radio button.
This selection enables or disables HTTPS. The default value is Enable. You can
download SSL certificates only when HTTPS is disabled.
You can enable HTTPS only if a
certificate is present on the device.
8. In the HTTPS Port field, type the HTTPS port number
.
The range is from 1025 to 65535. The default is port 443.
9. In the HTTPS Session Soft T
imeout (Minutes) field, enter the inactivity time-out for
HTTPS sessions.
The range is from 1 to 60 minutes. The default value is 5 minutes.
10. In the HTTPS Session Hard T
imeout (Hours) field, set the hard time-out for HTTPS
sessions.
This time-out is unaffected by the activity level of the session. The range is from 1 to 168
hours.
The default is 24 hours.
11. In the Maximum Number of HTTPS Sessions field, enter the maximum allowable number
of HTTPS sessions.
The range is from 1 to 4 sessions. The default is 4 sessions.
To Next Page
Loading...
Need help?
General