8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Manage Device Security User Manual349
7. In the Storm Control section, from the Ingress Control Mode menu, select one of the
following modes for storm control:
• Disabled. Storm control is disabled.
This is the default setting.
• Unknown Unicast. If the rate of incoming unknown Layer 2 unicast traf
fic (that is,
traffic for which a destination lookup failure occurs) increases beyond the configured
threshold on an interface, the traffic is dropped.
• Multicast. If the rate of incoming Layer 2 multicast traf
fic increases beyond the
configured threshold on an interface, the traffic is dropped.
• Broadcast. If the rate of incoming Layer 2 broadcast traf
fic increases beyond the
configured threshold on an interface, the traffic is dropped.
8. If the selection from the Ingress Control Mode menu is not Disabled,
specify whether the
ingress control mode is enabled by selecting Enable or Disable from the Status menu.
9. In the Threshold field, specify the maximum rate at which unknown packets are forwarded.
The range is a percent of the total threshold between 0 and 100%. The default is 5%.
10. From the Control Action mode menu, select one of the following options:
• None. No action is taken.
This is the default setting.
• Trap. If the threshold of the configured broadcast storm is exceeded, a trap is sent.
• Shutdown. If the threshold of the configured broadcast storm is exceeded, the port is
shut down.
11. Click the Apply button.
Your settings are saved.