8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Manage Device Security User Manual351
The default settings in the Port Settings section depends on the global storm control
settings (see
Configure global storm control settings on page 348), which apply to all
ports.
7. In the Port Settings section, select one or more interfaces by taking one of the following
actions:
• T
o configure a single interface, select the check box associated with the port, or type
the port number in the Go To Interface field and click the Go button.
• T
o configure multiple interfaces with the same settings, select the check box
associated with each interface.
• T
o configure all interfaces with the same settings, select the check box in the heading
row.
8. From the Status menu,
specify whether the ingress control mode is enabled for the port by
selecting Enable or Disable.
9. In the Threshold field, specify the maximum rate at which unknown packets are forwarded
for the port.
The range is a percent of the total threshold between 0 and 100%.
10. From the Control Action mode menu, select one of the following options for the port:
• None. No action is taken.
• Trap. If the threshold of the configured broadcast storm is exceeded, a trap is sent.
• Shutdown. If the threshold of the configured broadcast storm is exceeded, the port is
shut down.
11. Click the Apply button.
Your settings are saved.
To Next Page
Loading...
Need help?
General