8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud Management
Manage Device Security User Manual370
20. In the Source MAC Mask field, specify the source MAC address mask that must be
compared against the information in an Ethernet frame.
The format is xx:xx:xx:xx:xx:xx.
21. In the VLAN field, specify the VLAN ID that must be compared against the information in an
Ethernet frame.
The range is from 1 to 4095. Either VLAN range or VLAN can be configured.
22. From the Logging menu, select whether to enable or disable logging.
If you select Enable, logging is enabled for this ACL rule (subject to resource availability
on the switch).
23. Click the Add button.
The rule is added.
Change the match criteria for a MAC rule
To change the match criteria for a MAC rule:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the switch on-network and
connected to the Internet on page 19 or Access the switch off-network on page 30.
The login page displays.
If the NETGEAR Business page displays, see Register and access the switch with your
NETGEAR account on page 34.
4. Enter one of the following passwords:
• After registration, enter the local device password.
By default, the local device password is password.
• If you previously managed the switch through the Insight app or Cloud portal, enter
the Insight network password for the last Insight network location.
For information about the credentials, see Credentials for the local browser interface on
page 32.
5. Click the Login button.
The System Information page displays.
6. Select Security > ACL > Basic > MAC Rules.
The MAC Rules page displays.
To Next Page
Loading...
Need help?
General