NETGEAR UTM9S

Virtual Private Networking Using IPSec Connections
244
ProSecure Unified Threat Management (UTM) Appliance
To configure a VPN client tunnel, follow the steps in the following sections:
• Use the VPN Wizard to Configure the Gateway for a Client Tunnel on page 244.
• Use the NETGEAR VPN Client Wizard to Create a Secure Connection on page 246 or
Manually Create a Secure Connection Using the NETGEAR VPN Client on page 251.
Use the VPN Wizard to Configure the Gateway for a Client Tunnel
 To set up a client-to-gateway VPN tunnel using the VPN Wizard:
1. Select VPN > IPSec VPN > VPN Wizard. The VPN Wizard screen displays (see the
following figure, which contains an example for a multiple WAN port model). The WAN
radio drop-down lists are shown on the VPN Wizard screen for the multiple WAN port
models but not on the VPN Wizard screen for the single WAN port models.
Figure 142.
To display the wizard default settings, click the VPN Wizard default values option arrow
in the upper right of the screen. A pop-up screen displays (see Figure 138 on page 241),
showing the wizard default values. After you have completed the wizard, you can modify
these settings for the tunnel policy that you have set up.