Oce 9300 - Connecting to Host Environment

14 Océ 9300 User Manual
Connect the printer to your host
environment
The Océ 9300 supports several types of interfaces (Serial, Centronics, TCP/IP,
Novell Netware, NETBIOS, Ethertalk).
To ensure proper operation, please follow the steps below when connecting
your host to the Océ 9300.
1
Make sure that both the host and the Océ 9300 are turned OFF (see
‘Centronics’ on page 15).
2
Connect the appropriate interface cable to your local host and the
corresponding interface connector to the Océ 9300 (see ‘Centronics’ on
page 15) or (see ‘Configuring the printer's memory’ on page 22).
3
Turn on the Océ 9300 (see ‘Centronics’ on page 15).
4
Enter the Program mode in order to configure the connection parameters (see
‘Centronics’ on page 15) or (see ‘Configuring the printer's memory’ on
page 22).
5
Enter the Program mode to in order to configure the Océ 9300 to your
requirements (see ‘Printing files’ on page 40) or (see ‘Customizing defaults’
on page 45).
6
Leave Program mode, the printer is ready for use. If applicable, install and
configure the appropriate host software on your local host environment.