Oce 9300 - Leading and Trailing Edge

Printing files 43
▼
Programming Plot Center
1
Press ‘Program’ to enter the main menu.
2
Select ‘
MEDIA SETTING
’ item using the or button.
3
Press ‘next/select’ to enter the ‘
MEDIA SETTING
’ menu
.
4
Select the ‘
PLOT POSITION
’ item using the or button.
5
Press ‘next/select’ to enter the ‘
PLOT POSITION
’ menu.
6
Select the ‘
PLOT CENTER
’ item using the or button.
7
Press ‘next/select’ to enter the ‘
PLOT CENTER
’ menu.
8
Select the ‘
ON
/
OFF
’ using the or button.
9
Press ‘next/select’ to confirm the setting.
10
Press ‘Program’ to exit the main menu.
Leading/trailing edge
The leading edge setting can be used to add a white strip at the top of the image.
The page length will increase accordingly.
The trailing edge setting can be used to add a white strip at the end of the
image. The page length will increase accordingly.
Note:
The leading/trailing edge option only works if the cut method is set to
synchro cut.
The value for the trailing or leading edge can be set from 0 to 80 mm (in
increments of 5 mm) or 0 to +3 inch (in increments of
1
/
4
inch).
▼
Programming leading or trailing edge
1
Press ‘Program’ to enter the main menu.
2
Select ‘
MEDIA SETTING
’ item using the or button.
3
Press ‘next/select’ to enter the ‘
MEDIA SETTING
’ menu
.
4
Select the ‘
PLOT POSITION
’ item using the or button.
5
Press ‘next/select’ to enter the ‘
PLOT POSITION
’ menu.
6
Select the ‘
TRAILING
’ or
‘
LEADING EDGE
’ item using the or button.
7
Press ‘next/select’ to enter the ‘
TRAILING
’or ‘
LEADING EDGE
’ menu.
8
Select the required value using the or button.
9
Press ‘next/select’ to confirm the value.
10
Press ‘Program’ to exit the main menu.