60 Océ 9300 User Manual
HP-RTL
HP-RTL is a subset of HP-GL/2. Therefore, all HP-RTL plot data files must
start with ESC%-1BBPIN: or BPIN.
To use HP-RTL, the SELECT FORMAT should be set to AUTO or HP-GL/2
on the operating panel or HP-GL/2 must be selected via a remote control file.
Note:
HP-RTL plot data files must end with ESC%OB; PG; which will switch
the printer back to HP-GL/2 format mode. Without this command, the plot
results will be unpredictable and the printer will stop.
The following HP-RTL statements are not recognized by the Océ 9300 and
will be treated as no-ops: ESC*v#a, ESC*v#b, ESC*v#c, ESC*v#i,
ESC*v#W[data], ESC*b#l and ESC&b#V[data].
To Next Page
Loading...
