Oce 9300 - CalComp Double Synchronization

Customizing defaults 65
Double synchronization code parameter
The synchronization code parameter is significant in all cases in which
CalComp format is selected or auto-recognized, when select format is set to
Auto or a remote control command for CalComp has been sent.
The double synchronization parameter allows one or two synchronization
characters to identify the beginning of a message of print data. If set to double
synchronization, the same character is sent twice. The default is ‘No’.
▼
▼▼
▼
Setting the double synchronization code parameter
1
Press ‘Program’ to enter the main menu.
2
Select the ‘C
ONFIGURATION
’ item using the or button.
3
Press ‘next/select’ to enter the ‘C
ONFIGURATION
’ menu.
4
Select the ‘
DATA FORMAT
’ item using the or button.
5
Press ‘next/select’ to enter the ‘
DATA FORMAT
’ menu.
6
Select the ‘
CALCOMP SETUP
’ item using the or button.
7
Press ‘next/select’ to enter the ‘
CALCOMP SETUP
’menu.
8
Select the ‘
DOUBLE SYNC
’ item using the or button.
9
Press ‘next/select’ to enter the ‘
DOUBLE SYNC
’ menu.
10
Select the required double sync using the or button.
11
Press ‘next/select’ to confirm the selected value.
12
Press ‘Program’ to exit the main menu.