Oce 9300 - End of Plot Time Out

Advanced menu functions 73
End of plot time out
Normally, print files end with an instruction that tells the printer that the file is
finished.
However, some print data files do not have an end-of-print instruction. In such
cases, the print is considered 'finished' when the printer does not receive any
more graphic commands.
The print time-out option sets the delay after which the print is considered
finished. You can choose among the following options: 15, 30, 180, or 500
seconds. The default is 180.
▼
Defining the end of plot time-out
1
Press ‘Program’ to enter the main menu.
2
Select the ‘C
ONFIGURATION
’ item using the or button.
3
Press ‘next/select’ to enter the ‘C
ONFIGURATION
’ menu.
4
Select the ‘
DATA FORMAT
’ item using the or button
5
Press ‘next/select’ to enter the ‘
DATA FORMAT
’ menu.
6
Select the ‘
PLOT TIME OUT
’ item using the or button
7
Press ‘next/select’ to enter the ‘
PLOT TIME OUT
’ menu.
8
Select the required plot time-out using the or button.
9
Press ‘next/select’ to confirm the selected plot time-out.
10
Press ‘Program’ to exit the main menu.