Oce 9300 - CalComp Step Size

66 Océ 9300 User Manual
CalComp step size
If the data format type is set to CalComp (manual, auto selection, or remote
control command), seven steps or increments are provided (100 dpi to 4064
dpi). The default is 2032.
▼
▼▼
▼
Setting the appropriate step size
1
Press ‘Program’ to enter the main menu.
2
Select the ‘C
ONFIGURATION
’ item using the or button.
3
Press ‘next/select’ to enter the ‘C
ONFIGURATION
’ menu.
4
Select the ‘
DATA FORMAT
’ item using the or button.
5
Press ‘next/select’ to enter the ‘
DATA FORMAT
’ menu.
6
Select the ‘
CALCOMP SETUP
’ item using the or button.
7
Press ‘next/select’ to enter the ‘
CALCOMP SETUP
’menu.
8
Select the ‘
STEP SIZE
’ item using the or button.
9
Press ‘next/select’ to enter the ‘
STEP SIZE
’menu.
10
Select the required value using the or button.
11
Press ‘next/select’ to confirm the selected value.
12
Press ‘Program’ to exit the main menu.