Oce 9300 - Page 47

Customizing defaults 47
▼
▼▼
▼
Defining the pen settings
1
Press ‘Program’ to enter the main menu.
2
Select the ‘C
ONFIGURATION
’ item using the or button.
3
Press ‘next/select’ to enter the ‘C
ONFIGURATION
’ menu.
4
Select the ‘
PEN MENU
’ option using the or button.
1
Press ‘next/select’ to enter the ‘
PEN MENU
’.
For each pen setup, proceed as follows:
2
Select the ‘
PEN NUMBER
’ item using the or button.
3
Press ‘next/select’ to enter the ‘
PEN NUMBER
’menu.
4
Select the required ‘
PEN NUMBER
’ using the or button
5
Press ‘next/select’ to confirm the selected pen number.
6
Press ‘previous’ to re-enter the pen menu.
From this menu:
7
Select the ‘
PEN WIDTH
’ item using the or button.
8
Press ‘next/select’ to enter the ‘
PEN WIDTH
’menu.
9
Select the required pen width using the or button.
10
Press ‘next/select’ to confirm the selected pen width.
11
Press ‘previous’ to re-enter the pen menu.
12
Select the ‘
PEN PATTERN
’ item using the or button.
13
Press ‘next/select’ to enter the ‘
PEN PATTERN
’menu.
14
Select the appropriate pen pattern using the or button.
15
Press ‘next/select’ to confirm the selected pen pattern.
After programming all pen settings:
16
Press ‘Program’ to exit the main menu.