Olympus RollerFORM - Page 157

DMTA-20073-01EN, Rev. C, November 2015
List of Figures 151
Figure 6-30 Installing a ring in its retaining groove in the tire ...................................... 103
Figure 6-31 Installing the flange with the liquid-control valves .................................... 104
Figure 6-32 Tightening the captive screws of the flange that contains the liquid-control
valves from inside the liquid chamber ......................................................... 105
Figure 6-33 Installing the plain flange ............................................................................... 106
Figure 6-34 Installing the plain flange’s external retaining screws ............................... 107
Figure 6-35 Installing the bushing on the end of the probe-axle ................................... 108
Figure 6-36 Installing the acoustic wheel holding brackets ........................................... 109
Figure 6-37 Installing the probe’s angle-adjustment components ................................. 110
Figure 6-38 Cutting the cable tie off the RollerFORM handle ....................................... 111
Figure 6-39 Removing the screws from the RollerFORM handle ................................. 112
Figure 6-40 Loosening the rear roller’s retaining screw ................................................. 113
Figure 6-41 Pushing loose the rear roller’s axle from its seat ......................................... 114
Figure 6-42 Sliding out the rear roller’s axle ..................................................................... 115
Figure 6-43 Loosening the encoder retaining screw ........................................................ 116
Figure 6-44 Removing the Mini-Wheel encoder .............................................................. 117
Figure 6-45 The Mini-Wheel encoder installed on the alternate encoder holder ........ 118
Figure 6-46 Removing and pivoting the alternate encoder holder 90° ......................... 119
Figure 6-47 tightening the screw of the alternate encoder holder ................................. 120
Figure 6-48 Tightening the encoder retaining screw ....................................................... 122
Figure 6-49 Aligning the rear roller’s axle-end flat bevel with the retaining screw ... 123
Figure 6-50 Installing the handle cap on the RollerFORM’s handle ............................. 124
Figure 6-51 Installing the cable sheath and the cable tie ................................................ 125
Figure 6-52 Loosening the rear roller’s retaining screw ................................................. 126
Figure 6-53 Pushing loose the rear roller’s axle from its seat ......................................... 127
Figure 6-54 Sliding out the rear roller’s axle ..................................................................... 128
Figure 6-55 Loosening the encoder retaining screw ........................................................ 129
Figure 6-56 Removing the Mini-Wheel encoder .............................................................. 130
Figure 6-57 Aligning the rear roller’s axle-end flat bevel with the retaining screw ... 131
Figure 6-58 Loosening the screw of the alternate encoder holder ................................ 132
Figure 6-59 Removing and pivoting the alternate encoder holder 90° ......................... 133
Figure 6-60 The Mini-Wheel encoder installed on the alternate encoder holder ........ 134
Figure 6-61 Changing the batteries in the laser ................................................................ 135
Figure 6-62 Aligning the guiding laser beam ................................................................... 137
Figure 7-1 LEMO connector pinout diagram for EWIX1439 cable family ................. 141
Figure 8-1 RollerFORM — Exploded view ..................................................................... 144
Figure 8-2 Manual pump spare parts (P/N: ROLLERFORM-A-PUMP [Q7790006]) 147