Setting the Retry Function
FQ-CR2 User’s Manual
93
7
Convenient Functions
Setting scene retry
• Set the retry mode to [Scene retry] in "Retry details".
(Setup Mode) − [Sensor settings] − [Retry details]
Parameter Settings Description
Brightness
(shutter speed)
step
Brightness:
1 to 20, default: 2
Shutter speed:
0.01 to 1.00 (default: 1.00)
Sets the brightness or shutter speed step (msec).
Increment count 0 to 10 (default: 2) Sets the brightness (shutter speed) increment count.
Decrement
count
0 to 10 (default: 2) Sets the brightness (shutter speed) decrement count.
1 Press [Scene retry] for the retry mode.
2
Set the switch order.
3
Set the scenes that are switched through.
Parameter Settings Description
Switch Order Auto (default), Fixed Sets the scene switching order.
Auto:
Switches through the scenes in the order of highest frequency of use.
Fixed:
Switches through the scenes in the order that the scenes were registered for
scene switching.
Retry scene 1st to 32nd Register the scenes for scene switching.
Register the scenes to switch in order from Åg1st". If there are any scenes for scene
switching that are not registered, the remaining scenes are ignored.
FQ Sensor User Manual.book 93 ページ ２０１１年７月８日 金曜日 午後２時３０分
To Next Page
Loading...
