Omron JX - Page 59

3-9
3-3 Part Names and Descriptions of the Digital Operator
3
Operation
Mode key
Switches between: the monitor mode (d), the basic function mode
(F), and the extended function mode (A, b, C,
H).
With this key, you can always change the display as follows.
[Supplemental information]
To jump to “d001” from any function mode, hold down the Mode key for 3
seconds.
Note: Always press the Enter key to store any changed data.
Enter key
Enters and stores changed data.
(To change the set value, be sure to press the Enter key.)
Do not press the Enter key if you don’t want to store any changes, for example,
if you have changed the data inadvertently.
Increment key
Changes the mode.
Also, increases the set value of each function.
Decrement key
Changes the mode.
Also, decreases the set value of each function.
Name Description
or
f001 f001
58.1
58.0
57.9