representative can still directly connect to port 2 for troubleshooting when the port is
configured for LME. However, they must configure the laptop with a valid IP address
on the same subnet as Port 2.
Related Topics
• Configure Library Managed Encryption (LME)
Configure LME to have the library manage the encryption enrollment and key
delivery of all IBM LTO-6 or higher drives.
View Drive Information
The Drives table displays the type, location, and state of each drive in the library.
1. In the remote interface, select Drives in the left menu.
2. For more options, select a drive and then right-click or use the Actions drop-
down.
3. Note the drive state. The library polls the drive approximately every 10 seconds.
Possible states are:
• Empty
• Cleaning
• Loading
• Loaded
• Reading
• Writing
• Rewinding
• Unloading
Related Topics
• Tape Drives
Tape drives read and write data on tape cartridges. The SL150 supports LTO
half-height SAS and FC drives.
Configure Drive Cleaning
Manage drive cleaning in one of three ways: library-managed, host-managed, or
manually.
LTO drives may require occasional cleaning with a compatible cleaning cartridge. The
drive will notify the library or host application when it requires cleaning. Select your
method of managing drive cleaning:
• Enable Library-Managed Drive Auto Cleaning
• Configure Host-Managed Drive Cleaning
• Manually Clean a Drive (Not Recommended)
Chapter 7
View Drive Information
7-4
To Next Page
Loading...
