Oracle SL150 - 9 Service the Library; Place the Library Online or Offline

9
Service the Library
Perform routine library maintenance to correct library issues.
WARNING:
Oracle's StorageTek SL150 Modular Tape Library contains a Class-1 laser,
as defined by IEC 60825-1 Ed. 2 (2007). Use of controls or adjustments or
performance of procedures other than those specified herein may result in
hazardous radiation exposure.
This section covers routine procedures you may need to perform when servicing or
troubleshooting the library. For details on removing or replacing specific components,
see Replace Components (CRUs & FRUs).
• Place the Library Online or Offline
• Power On the Library
• Power Off the Library
• Restart the Library
• Audit the Library
• Move the Library Rack
• Enable the Locate Light
• Troubleshoot the Library
• Get Parts and Technical Support
• Run a Self-Test
Place the Library Online or Offline
Change the state of the library using the remote interface. An offline library will not
perform host operations.
Always take the library offline before performing any maintenance that might conflict
with host data operations. After you complete the disruptive activity, you can bring the
library back online and continue host operations.
1. If taking the library offline, stop any host activity before proceeding.
2. From the remote interface, click the Library is Online/Offline drop-down in the
upper-right.
3. Select either Set Library Offline or Set Library Online.
9-1