Oracle SL150 - Verify the SL150 Agent Is Enrolled; Review and Apply Configuration Wizard Changes; Update Firmware

This globally enables library managed encryption for all IBM LTO-6+ drives within
the library regardless of the partitioning configuration.
4. Enter the following information:
• OKM Cluster IP address
• Agent ID
• Agent Passphrase
5. Note the port that will be used for OKM communication in the "Connect to OKM
using:" field.
If you altered the Port 2 configuration, all LME traffic will go through Port 2. If you
left the Port 2 configuration set to the default values, LME traffic will go through
Port 1.
6. Leave the OKM tuning parameters at their default setting unless instructed to
change them by your OKM administrator.
7. Click Next. Review and apply the changes.
Verify the SL150 Agent is Enrolled
Confirm the library is enrolled as an agent in OKM.
After confirming the changes within the Configuration Wizard, have the OKM
administrator go to the OKM GUI and verify that the SL150 agent now shows
"Enrolled: True".
See the OKM documentation for more information.
Review and Apply Configuration Wizard Changes
Verify and accept changes you made in the configuration wizard to apply the settings.
1. Within the configuration wizard, review the Summary of Configuration Changes
screen. Altered settings are indicated by "changed" or "added" in the changes
column.
2. Note any alerts
at the bottom of the screen.
3. If you see a problem, click Previous to return to an earlier screen or Cancel to
quit.
4. Otherwise, select the Accept all changes check box, and then click Apply.
Update Firmware
Regularly check for firmware updates. Keep the library and drives up to date.
• Identify Current Firmware Versions
• Download Firmware from My Oracle Support
• Update the Library Firmware
• Update the Drive Firmware
• Revert to the Previous Library Firmware
Chapter 4
Update Firmware
4-9