List of Figures
1-1 Base Module and Two Expansion Modules (Front View) 1-1
1-2 Base Module and Expansion Modules (Rear View) 1-2
1-3 Front Control Panel Home Screen 1-6
2-1 Rear View of Sun Rack II (PDU on Right Side) 2-4
2-2 Base Module Accessory Package Mounting Hardware 2-6
2-3 Back Rail Position 2-7
2-4 Back Rails Installed 2-8
2-5 Front Rail Installation (Left Rail Shown) 2-9
2-6 Mounting Block for Front Rail (Right Rail Shown) 2-10
2-7 Rails Installed - Front View 2-11
2-8 Clip Nut Location for the Base Module 2-11
2-9 Tab and Rail Engagement 2-12
2-10 Cable Clip Removal 2-14
2-11 Expansion Module 2-15
2-12 Expansion Module Accessory Package Hardware 2-16
2-13 Library Floor Removal from the Base Module 2-17
2-14 Expansion Module Clip Nut Installation 2-18
2-15 Magazine Latches 2-19
2-16 Library Floor 2-20
2-17 Floor Secured 2-20
2-18 Scratch Avoidance 2-21
2-19 Alignment Tab Seated 2-22
2-20 Expansion Module Back Rail and Clip Nut 2-22
2-21 Expansion Module ID Label 2-24
2-22 Hook and Loop Strap 2-24
2-23 SL150 Library Rear View 2-25
2-24 Power Supply 2-26
2-25 Tape Drive Tray 2-26
2-26 Initial Cabling Example 2-29
2-27 Cabling the Expansion Modules 2-31
6-1 Correct Label Orientation 6-6
8-1 LEDs on Front of Base Module 8-2
8-2 LEDs on Rear of Base Module 8-3
8-3 LEDs on Rear of the Expansion Module 8-3
10-1 Tape Drive Tray CRU (HP LTO-5) 10-3
xii
To Next Page
Loading...
