Install the Main Module
104 SPARC T5-4 Server Service Manual • July 2016
The levers should click into place when the module is fully seated in the server.
5.
Connect the power cords.
See “Connect Power Cords” on page 191.
6.
If the you are replacing the main module with a new one, connect a terminal or a
terminal emulator (PC or workstation) to the SER MGT port.
The following message is delivered over the serial management port.
Unrecognized Chassis: This module is installed in an unknown or
unsupported chassis. You must upgrade the firmware to a newer
version that supports this chassis.
7.
Download the system firmware.
a.
Configure the SER MGT port to enable the firmware image to be
downloaded.
To Next Page
Loading...
