Verify the Service Processor Card
120 SPARC T5-4 Server Service Manual • July 2016
■
target is the remote location where you stored the configuration information.
For example:
-> load -source tftp://129.99.99.99/pathname
8.
Verify the installation of the service processor card.
See “Verify the Service Processor Card” on page 120.
Related Information
■
“Determine if the Service Processor Card Is Faulty” on page 115
■
“Remove the Service Processor Card” on page 116
■
“Verify the Service Processor Card” on page 120
Verify the Service Processor Card
1.
Verify that the SP LED on the main module or rear I/O module is lit green.
See “Main Module LEDs” on page 98 or “Rear I/O Module LEDs” on page 173.
2.
Verify that the front and rear Service Required LEDs are not lit.
See “Interpreting LEDs” on page 28.
3.
Perform one of the following tasks based on your verification results:
■
If the previous steps did not clear the fault, see “Diagnostics Process” on page 23.
■
If the previous steps indicate that no faults have been detected, then the service processor
card has been replaced successfully. No further action is required.
Related Information
■
“Determine if the Service Processor Card Is Faulty” on page 115
■
“Remove the Service Processor Card” on page 116
■
“Install the Service Processor Card” on page 118
To Next Page
Loading...
Need help?
General