Oracle SPARC T5-4 - Servicing the Rear I;O Module

Servicing the Rear I/O Module 173
Servicing the Rear I/O Module
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This discharge can cause failure of server components.
Caution - You must disconnect the power cords before servicing this component. See
“Disconnect Power Cords” on page 53.
These topics describe service procedures for the rear I/O module in the server.
■
“Rear I/O Module LEDs” on page 173
■
“Determine if the Rear I/O Module Is Faulty” on page 175
■
“Remove the Rear I/O Module” on page 176
■
“Install the Rear I/O Module” on page 178
■
“Verify the Rear I/O Module” on page 180
Rear I/O Module LEDs
The LEDs on the rear I/O module give server status information and link information on the
NET ports.