Run POST With Maximum Testing
Detecting and Managing Faults 37
Related Information
■
“POST Overview” on page 33
■
“Oracle ILOM Properties That Affect POST Behavior” on page 33
■
“Run POST With Maximum Testing” on page 37
■
Oracle ILOM Documentation Library
Run POST With Maximum Testing
This procedure describes how to configure the server to run the maximum level of POST.
1.
Log in to Oracle ILOM.
See “Log In to Oracle ILOM (Service)” on page 26.
2.
Set the virtual keyswitch to diag so that POST runs in service mode.
Alternatively, you can use the /System target.
-> set /HOST keyswitch_state=diag
Set ???keyswitch_state' to ???Diag'
3.
Run POST.
Alternatively, you can use the /System target.
-> start /System
Are you sure you want to start /System (y/n)? y
Starting /System
Related Information
■
“POST Overview” on page 33
■
“Oracle ILOM Properties That Affect POST Behavior” on page 33
■
“Configure POST” on page 35
■
Oracle ILOM Documentation Library
Managing Faults
These topics describe the Predictive Self-Healing feature.
■
“PSH Overview” on page 38
■
“Check for Faults” on page 38
To Next Page
Loading...
Need help?
General