Oracle SPARC T5-4 User Manual

Configure POST
36 SPARC T5-4 Server Service Manual • July 2016
This example sets the virtual keyswitch to normal, which configures POST to run according to
other parameter values.
-> set /HOST keyswitch_state=normal
Set ???keyswitch_state' to ???Normal'
For possible values for the keyswitch_state parameter, see “Oracle ILOM Properties That
Affect POST Behavior” on page 33.
3.
If the virtual keyswitch is set to normal, and you want to define the mode, level,
verbosity, or trigger, set the respective parameters.
Syntax:
set /HOST/diag property=value
See “Oracle ILOM Properties That Affect POST Behavior” on page 33 for a list of
parameters and values.
Examples:
-> set /HOST/diag mode=normal
-> set /HOST/diag verbosity=max
4.
View the current values for settings.
Example:
-> show /HOST/diag
/HOST/diag
 Targets:
 Properties:
 error_reset_level = max
 error_reset_verbosity = normal
 hw_change_level = max
 hw_change_verbosity = normal
 level = min
 mode = normal
 power_on_level = max
 power_on_verbosity = normal
 trigger = hw_change error-reset
 verbosity = normal
 Commands:
cd
set
show
->

Oracle SPARC T5-4 Specifications

General

Brand	Oracle
Model	SPARC T5-4
Category	Server
Language	English